You are not logged in.

#1 2018-07-09 15:09

Rademes
Member
Registered: 2015-12-13
Posts: 327

Checksum verification, silent reboot

Good day!
When I boot Live USB with Q4OS 2.5, I often use boot parameter verify-checksums to verify integrity.
The problem is, that after successful verification, PC just reboots silently without showing a single word.
Can you make, that after successful checksum verification a message Checksum verification successful, press any key to reboot your system appeared, and PC rebooted only after pressing a keyboard key.
Similar message appears in Linux Mint for example after successful verification.
P.S. Before installing Linux, I always perform checksum verification to avoid installation problems in future.

Last edited by Rademes (2018-07-09 15:10)

Offline

Board footer

Powered by FluxBB